UPDATE 10/4 6:47 EDT

I have been going through all the comments. THANKS!!! I did not know about the techniques listed, so they are extremely helpful. Sorry for the slow update. As I mentioned below, I got behind with this yesterday so work cut into my evening.

I ran a port scan. The first syntax, -p, brought no joy. The nmap software itself suggested changing to -Pn. That brought an interesting response:

nmap -Pn 1-9999 <Local IP Addr>

Starting Nmap 7.93 ( https://nmap.org ) at 2024-10-04 11:44 BST Failed to resolve “1-9999”. Nmap scan report for <Local IP Address> Host is up (0.070s latency). All 1000 scanned ports on 192.168.0.46 are in ignored states. Not shown: 990 filtered tcp ports (no-response), 10 filtered tcp ports (host-unreach)

Nmap done: 1 IP address (1 host up) scanned in 6.03 seconds

Just to be absolutely sure, I turned off my work computer (the only windows box on my network) and reran the same syntax with the same results.

As I read this, there is definitely something on my network running windows that is not showing up on the DHCP.

  • fubarx@lemmy.ml
    11·
    21 hours ago

    There was an appliance where the wifi chip was at the end of the power cable, embedded inside the plug. From the outside, you couldn’t really tell. It was there so radiation inside the box couldn’t affect the wireless signal as much.

    I can imagine some genius thinking it’s a good idea to run a server from inside a cable or a connected home appliance.