• 0 Posts
  • 25 Comments
Joined 1 year ago
cake
Cake day: June 14th, 2023

help-circle
  • I’m not sure of the floor plan or roof type. But what I do is run a cable up the corner and drill a tiny hole right in the corner through the ceiling. Then I use a PoE powered access point and leave it in the ceiling space centrally located. One tiny hole you can patch with just about anything when you move house. If you have a rj45 crimper then the hole can be the diameter of the cable.

    I’ve also done something similar where I run Ethernet under the floor. I lift up the carpet slightly right in the corner and drill a hole through the floor and run the Ethernet under the house. You also then take it up into a closet etc.

    If you’re more adventurous and confident with electrical work you can also TURN OFF MAINS, then open up a wall power socket, disconnect the wires, tie a pull wire and your Ethernet cable very securely, and go into the roof and pull the two through into the roof space. You then tie the end of the elec cable to your pull wire and pull it back down to the socket. You can then get a wall plate that is a power socket and Ethernet female combo and voila….












  • Heh welcome!

    If I was to give anyone advice it’d be to set up a way to make really solid notes/documentation. Be it a text/markdown file or a google doc. Put down the commands you run, put down the steps and then a link to where you found it. As you muck around and so on you’re going to remember that you wanted to get xyz going and you struggled and you can then refer back to those notes.

    That has been the single most valuable thing I’ve learnt from this whole Linux endeavour I’ve been on.

    When I reinstall I just follow my notes to get all the devices and so on going. Definitely worth the trouble!

    Good luck and tell us how you go!